Bearings

Ball Bearings - Metric

Ball Bearings - Imperial

Angular Contact Ball Bearings

Taper Roller Bearings

Thrust Ball Bearings

Needle Roller Bearings

Needle Roller Clutches

Needle Roller Thrust Bearings

Pillow Blocks

Take-up Units

Truloc Engineering Adhesives

We have been supplying ball, roller, and needle roller bearings to trade and industry since 1986. Here is a small selection of sizes we carry in stock. In addition to these, if you have any other bearing requirements for a project, or for replacement, please give us a call. It helps to identify your requirements more precisely if you have the following information to hand:

Type of bearing: ball, roller, needle roller, taper roller, spherical roller, self-aligning ball, thrust ball, thrust roller, combination ball & roller, etc.
marks and numbers which are normally to be found somewhere on the bearings.
Inside dia. (I.D.) x outside dia. (O.D.) x width (W). Bearing dimensions are normally presented in this format.

Most bearings, especially for industrial applications follow an internationally recognised bearing identification system. In some cases, the bearing will have a prefix, followed by a group of numbers, followed by a suffix. Some of the common prefixes and suffixes are mentioned below:

Prefix	Suffix
S = Stainless Steel	RS = Single Rubber Seal
F = Flanged	2RS = 2 Rubber Seals
MR = Metric	Z = Single Metal Shield
MF = Metric Flanged	ZZ= 2 Metal Shields
R = Inch

Except for "S", all bearings are made from ball bearing chrome steel. All "S" are stainless steel.

Discount: 15% discount applies when you order 10+ of one bearing type.